Yeti For Christmas Slider Surprise

 

Yeti Slider Surprise Flat Card

My Favorite Things-Beast Friends BB-143

MFT- A2 Slider Surprise Die-cuts

Lawn Fawn Stitched Hillside Border Dies

Simon Says Stamp- Yeti for Christmas sss302447c

Echo Park- Winter 12x12 Paper - S

Cardstock- Accent Opaque 120lb Cardstock or Neenah 110 lb.

Black Ink- VeraFine Onyx Black, Distress Oxide Stormy Sky

Distress Inks- Pumice Stone, Vintage Photo, Tumbled Glass, Barn Door, Pine Needles

Distress Oxide- Speckled Egg or Tumbled Glass

Adhesives- Foam cut to 1/4” wide or less, liquid glue, score tape

Foam board I use...HERE

Ribbon and Jute Twine

We'll start by water-coloring with Distress Inks all of our stamped and cut out images, stamp the feet on the card flat panel (if you want a back sentiment do this at this time as well), build the slider element, and then decorate and adhere images to card front panel. Finish by adding the ribbon to the slider piece and add any embellishments to finish it off.  And of course test out those sliders.  

Here is the how to on making a slider surprise panel without the die-cut.

4"x5 1/4" Panel leave a 5/8" Border on all sides So cut from 5/8" to 4 5/8" on the long sides, then cut from 5/8" to 3 3/8" on one end of the short side. Score only in between the cuts. With the top being the non cut short side, score at 5/8", 2 3/8", and 4 1/8" Find the middle top center, 2" and mark. Using a 1" circle cutter or die center about 1/4"- 3/8" into the top border and make a cut. (this gives you some room to grasp the pull tab panel) Note: if you cut your pull tab panel longer and let it hang out the top, you could go with out the notch. Pull Tab Panel measures- 4 4/8"x 3 1/4" I hope that helps. Let me know if you have any questions.

Thanks for watching, reading, subscribing, and all the things! Keep Getting Inky,

Jaime

Make sure to check out the affiliate links on the side as there are lots of Black Friday Sales week specials going on now!